KIOSK Hardware Set Up
Learn how to configure and assemble KIOSK hardware components to create a secure, optimized software setup.
If you still have questions or prefer to get help directly from an agent, please submit a request.
We’ll get back to you as soon as possible.
- Emergency Management Suite
- Navigate360 Training Institute
- Behavioral Threat Assessment Case Manager
- Visitor Management
- School Check In
- ALICE Training Institute
- Detect - Social Sentinel
- P3 - Anonymous Tip Reporting
The Elo Kiosk comes in several parts that need to be assembled. It is impossible to ship the kiosk fully assembled because shipping a fully assembled Kiosk would likely result in damage from shipping.
A single kiosk will consist of three (3) parts:
- Kiosk stand
- Kiosk driver license scanner
Open the kiosk box. The kiosk and barcode scanner are in one box and the stand is in another separate box.
Remove the back panel.
- Power On/Off Button
- Speaker Volume Control
- Screen Brightness Control
- Power Plug
- USB Ports
- RJ 45 Network Connection
KIOSK STAND SET UP
The Kiosk stand consists of six (6) parts:
- Three (3) screws used to attach the base to the stand
- Kiosk Mounting Bracket
- End Cap for Kiosk Stand
- Four (4) screws used to attach Mounting Bracket to Kiosk (not shown on this page)
The Kiosk stand consists of six (6) parts.
- Fit stand into base. It only fits in one way.
- Insert base screws through bottom of base into the holes in the stand.
- Tighten the screws.
MOUNTING BRACKET INSTALLATION
Lay Kiosk screen side down on a protective cloth or other protective item.
Place mounting bracket onto back of kiosk.
Which Way Should The Mounting Bracket Be Set?
This is a top down view looking down on the bracket. The screw head should be showing.
- Place mounting bracket onto back of kiosk.
- Insert small screws through bracket into kiosk holes. Do not tighten screws until all four are inserted.
- Tighten each screw about half way. Work your way around all four screws tighten 1 turn, then next screw 1 turn, etc…
DO NOT over-tighten the screws.
- Attach the mounting bracket and kiosk using the outer holes.
ATTACHING THE BARCODE SCANNER
Connect the following cables/cords according to the pictures below.|
- Lift Kiosk up and slide on to stand.
- Secure Kiosk to stand by tightening the turn knob
Scanner light illuminated on Kiosk’s side and front view.